The Cisco Hyperlocation detection threshold is currently set to -50 dBm. After reviewing the wireless user location, dis

[answerhappygod]

The Cisco Hyperlocation detection threshold is currently set to -50 dBm. After reviewing the wireless user location, discrepancies have been noticed. To improve the Cisco Hyperlocation accuracy, an engineer attempts to change the detection threshold to -100 dBm. However, the Cisco Catalyst 9800 Series Wireless
Controller does not allow this change to be applied. What actions should be taken to resolve this issue?

A. Disable Cisco Hyperlocation, change the Cisco Hyperlocation detection threshold, and then enable it.
B. Create a new profile on Cisco CMX with the new Cisco Hyperlocation detection range, and apply it on the WLAN.
C. Place the APs to monitor mode, shutdown the radios, and then change Cisco Hyperlocation detection threshold.
D. Shutdown all radios on the controller, change the Cisco Hyperlocation detection range, and enable the radios again.