✑ Enter IOS commands on the device to verify network operation and answer the multiple-choice questions.
✑ THIS TASK DOES NOT REQUIRE DEVICE CONFIGURATION.
✑ Click on SW1, SW2, New_Switch or SW4 to gain access to the consoles of these devices. No console or enable passwords are required.
✑ To access the multiple-choice questions, click on the numbered boxes on the left of the top panel.
✑ There are four multiple-choice questions with this task. Be sure to answer all four questions before selecting the Next button
Scenario -
You have been asked to install and configure a new switch in a customer network. Use the console access to the existing and new switches to configure and verify correct device configuration.
Topology -
Refer to the configuration. For which configured VLAN are untagged frames sent over trunk between SW1 and SW2?
- Instructions En 1 (48.97 KiB) Viewed 57 times
- Instructions En 2 (14.83 KiB) Viewed 57 times
- Instructions En 3 (13.83 KiB) Viewed 57 times
- Instructions En 4 (21.44 KiB) Viewed 57 times
- Instructions En 5 (13.71 KiB) Viewed 57 times
B. VLAN 99
C. VLAN 999
D. VLAN 40
E. VLAN 50
F. VLAN 200
G. VLAN 300