An engineer is working on a ticket that reports TEL1 cannot call TEL2. These dial peers are configured to route the call between the endpoints. dial-peer voice 2001voip destination-pattern 2001 session protocol sipv2 session target ipv4:10.1.1.2 incoming called-number . codec g722-64 video codec h264 dtmf-relay rtp-nte sip-notify sip-kpml no vad dial-peer voice 3001 voip destination-pattern 3001 session protocol sipv2 session target ipv4:10.3.1.2 incoming called-number . codec g722-64 video codec h264 dtmf-relay rtp-nte sip-notify sip-kpml no vad
While troubleshooting, the engineer discovers that the Cisco Unified Border Element is giving the error "SIP/2.0 403 Forbidden". Which two Cisco Unified Border
Element configurations resolve this issue? (Choose two.)
- Refer To The Ex 1 (52.88 KiB) Viewed 48 times
B. voice service voip no ip address trusted authenticate mode border-element allow-connections sip to sip sip bind control source-interface loopback0 bind media source-interface loopback0
C. voice service voip mode border-element ip address trusted list allow-connections sip to sip sip bind control source-interface loopback0 bind media source-interface loopback0
D. voice service voip mode border-element allow-connections sip to sip sip bind control source-interface loopback0 bind media source-interface loopback0
E. voice service voip mode border-element ip address trusted list ipv4 10.1.1.0 255.255 255.0 ipv4 10.3.1.0 255.255.255.0 allow-connections sip to sip sip bind control source-interface loopback0 bind media source-interface loopback0