Which two command sequences must be configured on a switch to establish a Layer 3 EtherChannel with an open-standard pro
Posted: Fri Jul 22, 2022 2:47 pm
Which two command sequences must be configured on a switch to establish a Layer 3 EtherChannel with an open-standard protocol? (Choose two.)
A. interface GigabitEthernet0/0/1 channel-group 10 mode auto
B. interface GigabitEthernet0/0/1 channel-group 10 mode on
C. interface port-channel 10 no switchport ip address 172.16.0.1 255.255.255.0 Most Voted
D. interface GigabitEthernet0/0/1 channel-group 10 mode active Most Voted
E. interface port-channel 10 switchport switchport mode trunk
A. interface GigabitEthernet0/0/1 channel-group 10 mode auto
B. interface GigabitEthernet0/0/1 channel-group 10 mode on
C. interface port-channel 10 no switchport ip address 172.16.0.1 255.255.255.0 Most Voted
D. interface GigabitEthernet0/0/1 channel-group 10 mode active Most Voted
E. interface port-channel 10 switchport switchport mode trunk