Refer to the exhibit: How should the FastEthernet0/1 ports on the 2950 model switches that are shown in the exhibit be

[answerhappygod]

Refer to the exhibit:

How should the FastEthernet0/1 ports on the 2950 model switches that are shown in the exhibit be configured to allow connectivity between all devices?

Refer To The Ex 1 (327.35 KiB) Viewed 48 times

A. The ports only need to be connected by a crossover cable.
B. SwitchX(config)# interface fastethernet 0/1 SwitchX(config-if)# switchport mode trunk
C. SwitchX(config)# interface fastethernet 0/1 SwitchX(config-if)# switchport mode access SwitchX(config-if)# switchport access vlan 1
D. SwitchX(config)# interface fastethernet 0/1 SwitchX(config-if)# switchport mode trunk SwitchX(config-if)# switchport trunk vlan 1 SwitchX(config-if)# switchport trunk vlan 10