Refer to the exhibit. A network administrator has configured a Catalyst 2950 switch for remote management by pasting in

[answerhappygod]

Refer to the exhibit.

A network administrator has configured a Catalyst 2950 switch for remote management by pasting into the console the configuration commands that are shown in the exhibit. However, a Telnet session cannot be successfully established from a remote host. What should be done to fix this problem?

Refer To The Ex 1 (26.25 KiB) Viewed 47 times

A. Change the first line to interface fastethernet 0/1.
B. Change the first line to interface vlan 0/1.
C. Change the fifth line to ip default-gateway 192.168.17.241.
D. Change the fifth line to ip route 0.0.0.0 0.0.0.0 192.168.17.1.
E. Change the sixth line to line con 0.