A) Specify and draw the General Arrangement of a airport hanger The hangar should accommodate: 1. one plane 2. a worksho

[answerhappygod]

A) Specify and draw the General Arrangement of a airport hanger
The hangar should accommodate: 1. one plane 2. a workshop area
located in front of the plane. The hangar is to be framed using
portal frames of constant width and height. Plane Particulars are
as follows Crew: one (1) • Capacity: three (3) passengers • Length:
8.28 m; Height: 2.72 m • Wingspan: 11.00 m • Wing area: 16.2 m2 •
Empty weight: 767 kg • Gross weight: 1,111 kg • Fuel capacity: 212
litres • Powerplant: LycomingIO-360-L2A 4 cylinder, horizontally
opposed aircraft engine, 160hp (120 kW) • Propellers: 2-bladed
metal The hangar requirements are: • The portal frame must be wide
enough to accommodate the plane plus a minimum of 3.0m on either
side. • The portal frame must be long enough to accommodate the
plane plus a minimum of 4m on both ends. • A 2.0ton crane is
required in the hangar. The crane must be able to reach the entire
plane and deliver items to the edge of the workshop. • The portal
frame must be high enough to accommodate the plane height plus 1.0m
at the door. • A sliding hangar door is required to secure the
facility. The door must provide a minimum clear opening of plane
width plus 1.25m. Specify the type and weight of door. Design the
supporting structure. • The workshop must span the width of the
hangar and must be at least 250m2. The workshop floor level must be
the same as the hangar.