Part A Draw the shear diagram for the beam Follow the sign convention. (Eigue 1) Click on "add vertical line off to add

[answerhappygod]

Part A Draw The Shear Diagram For The Beam Follow The Sign Convention Eigue 1 Click On Add Vertical Line Off To Add 1 (32.17 KiB) Viewed 38 times

Part A Draw the shear diagram for the beam Follow the sign convention. (Eigue 1) Click on "add vertical line off to add discontinuity lines. Then click on "add segment" button to add functions between the lines Note 1 - You should not draw an extra discontinuity line at the point where the curve passes the x-axis. Note 2. The curve you choose from the drop down is only a pictorial representation of a real quadrati cubic curve. The equation of this curve is not mathematically equivalent to the correct answer. Consequently slopes at discontinuities and intercepts with the x-axis (if any) are not accurate. Note 3. Be sure to indicate the correct types of the functions between the lines, o.g. it in your answer the type of a function is lineat increasing slope for the function that actually has linear decreasing slope, the answer will be graded as Incorrect. Use the button "change segment if necessary Figure C1 of 1 12 kN/m 3 m 3m C 6 m No elements selected V (N)