Build the below network topology (10 Marks): PC1 PC2 Fao Fao Fa0/2 R1 Muharraq 1000 Hosts Fa0/1 witcho Gigor1 Gigo/1 Seo

[answerhappygod]

Build The Below Network Topology 10 Marks Pc1 Pc2 Fao Fao Fa0 2 R1 Muharraq 1000 Hosts Fa0 1 Witcho Gigor1 Gigo 1 Seo 1 (41.46 KiB) Viewed 36 times

Build The Below Network Topology 10 Marks Pc1 Pc2 Fao Fao Fa0 2 R1 Muharraq 1000 Hosts Fa0 1 Witcho Gigor1 Gigo 1 Seo 2 (43.36 KiB) Viewed 36 times

Build the below network topology (10 Marks): PC1 PC2 Fao Fao Fa0/2 R1 Muharraq 1000 Hosts Fa0/1 witcho Gigor1 Gigo/1 Seo/0/0 Gigort R4 Seo/1/0 Se0/0/1 S0/0/0 Se0/0/0 Seo/0/1 Gigort Se0/1/1 Swil Gigo/1 R2 Fa0/1 Fa0/2 Fa0 Fa0 Hamad Town 200 Hosts Gigort PC7 Figure 1 Small network configuration S40/0/1 R3 Fa0/2 Fa0/1 Budalya 100 hosts Gigort Gigo/1 Fa0 Saar 16 hosts Fao Switch2 Fa0/1 PCS Web Server Fab PC3 Fa0/2 Fao
Q2. PCs configuration (5 Marks): 1. Connect the topology shown in figure I using Packet Tracer. 2. Use table 1 to assign IPs in table 3 to all PCs including the Default Gateway. IP address Default Gateway Device PC 1 PC 2 PC 3 PC 4 PC S PC 6 PC 7 Web Server Device BLI RI 812 82 R3 R3 RA KA ▬▬▬▬▬▬▬▬▬ SAMG Use table 1 and table 2 to sign IP's to Routers interfaces 2. Make sure you enable the interface (no shutdown) 2298 XO RO Device R1 R2 R3 3 9 Table 3 IP addressing for PCs using Classless Subnetting Q5. Use RIP protocol to bridge the LAN networks (15 Marks): 1. Apply RIPv2 in all routers. Use table 4 to show all the codes you plan to use 2. Once all codes are applied in the routers, use "show ip route" to make sure all networks are known to the Routers. Resolve any issue if not all networks are known. RIP Configuration commands NO Subnet Mask Interface 5000 001 5000 GOT 50/0/1 GO 800/1 001 IP address Suboot Mask 5050 500/1 50/1/0 50/1/1 Table 4 IP addressing for Routers using Classless Subnetting. Toble 4 RIP configuration for all routers-Classless