- 2 Open Atmel Studio And Write A Program That Converts The Analog Value Read From A Potentiometer And Display The Resu 1 (92.91 KiB) Viewed 84 times
arduino code
LDI, SBI , SBIS.....
I NEED A CLEAR CODE
2. Open "Atmel Studio" and write a program that converts the analog value read from a potentiometer and display the result on PORTD. 3. Connect the following circuit using Protues: 4 RV1 LAB Simulation 1k <TEXT 14 15 16 17 18 19 9 10 23 24 25 26 FFF 27 28 1 U1 PBOICP1/CLKO/PCINTO PB1JOCIA/PCINT1 PDDRXDIPCINTIE PD1/TXD/PCINT17 PB2/SS/OC1B/PCINT2 PD2ANTO/PCINT18 PB3/MOSUOC2A/PCINT3 PD3/NT1/0C2B/PCINT19 PB4/MISO/PCINTA PD4/TOXCK/PCINT20 PD5/T1/0C0B/PCINT21 PB5/SCK/PCINT5 PB6/TOSC1/XTAL1/PCINT6 PD6/AINO/OCOAPCINT22 PB7/TOSC2XTAL2/PCINT7 POTIAIN1/PCINT23 PCO/ADCOPCINTB PC1/ADC1/PCINT9 PC2/ADC2/PCINT10 PC3/ADC3/PCINT11 PC4/ADC4/SDA/PCINT12 PCS/ADC5/SCL/PCINT13 PC6/RESET/PCINT14 ATMEGA328P TEXT 4 AREF AVCC 3 4 5 6 11 12 13 21 20 D1 • Update the previous code to write the resistance value on an LCD. LEO-RED TEXT D2 LED-RED TEXT D3 LED-RED D4 LED-RED TEXT- D5 LED-RED D6 LED-RED TEXT D7 LED-RED D8 Figure 5-4 Circuit Design 4. Upload the .hex file, simulate, and observe the result. 5. Use the same setup to upload the code to the Arduino UNO board and observe the result. LED-RED TEXT-