Objective To conduct experiment on Op amp application Circuit Diagram R₁ 1.1K www Vi 1.5 V Procedure R₁ LIK ww S 1.5 V R

[answerhappygod]

Objective To Conduct Experiment On Op Amp Application Circuit Diagram R 1 1k Www Vi 1 5 V Procedure R Lik Ww S 1 5 V R 1 (38.22 KiB) Viewed 41 times

Objective To conduct experiment on Op amp application Circuit Diagram R₁ 1.1K www Vi 1.5 V Procedure R₁ LIK ww S 1.5 V R 2.2K www + 741 +15V - ISV 6 No 1. Check the components. 2. Setup the circuit on the breadboard and check the connections. 3. Switch on the power supply. 4. Give V₁ V₂ = +1.5V DC with polarity as shown in fig. 1. 5. Make sure that the CRO selector is in the D.C. coupling position. 6. Observe input and output on two channels of the oscilloscope simultaneously. 7. Note down and draw the input and output waveforms on the graph. 8. Verify that the output voltage is -6VDC 9. Repeat the procedure with V₁=1Vpp / 1 KHz sine wave and V₂ = +1.5Vdc as shown