1. 2. When fluorescent fixtures are installed in recreation rooms, fixture whips constructed of of flexible metal condui

[answerhappygod]

1 2 When Fluorescent Fixtures Are Installed In Recreation Rooms Fixture Whips Constructed Of Of Flexible Metal Condui 1 (34.98 KiB) Viewed 62 times

1 2 When Fluorescent Fixtures Are Installed In Recreation Rooms Fixture Whips Constructed Of Of Flexible Metal Condui 2 (46.05 KiB) Viewed 62 times

1. 2. When fluorescent fixtures are installed in recreation rooms, fixture whips constructed of of flexible metal conduit are used. a. b. ό C. d. Receptacles installed to serve countertop surfaces must be GFCI protected if they are within feet of the outer edge of a wet bar sink. a. 2 b. 4 6 8 C. d. 18 to 24 inches 2 to 3 feet 4 to 6 feet 6 to 8 feet 3. A multiwire branch circuit allows a. b. C. d. one 3-wire circuit to do the job of two 3-wire circuits one 3-wire circuit to do the job of two 2-wire circuits two or more 3-wire circuits to use the same conduit the creation of a long 2-wire series circuit
5. 7. When connecting a 3-wire circuit to the panel, the be connected to the opposite phases in the panel. 8. a. ن نه من b. C. d. a. b. According to your reading material, the biggest factor in deciding whether to use cable or electrical metallic tubing in a recreation room is the c. d. 6. Which of the following formulas is CORRECT? amperes = watts/volts b. amperes = volts/watts amperes = ohms/watts d. amperes = ohms/volts a. ܡ ܪ ܩ ܗ C. a. b. red and white black and white black and red white and ground C. d. size and type of wall furring room size In the workshop model traced in your reading material, all wiring is. EMT a. b. type of switches used distance between the room and the service entrance C. d. conductors must BX UF flexible cord Nichrome wire, which is commonly used to make heating elements, has a "hot" higher than its "cold" resistance. resistance that is approximately. 5% 10% 20% 25%