SolarWinds Professional Questions + Answers

Business, Finance, Economics, Accounting, Operations Management, Computer Science, Electrical Engineering, Mechanical Engineering, Civil Engineering, Chemical Engineering, Algebra, Precalculus, Statistics and Probabilty, Advanced Math, Physics, Chemistry, Biology, Nursing, Psychology, Certifications, Tests, Prep, and more.
Post Reply
answerhappygod
Site Admin
Posts: 899603
Joined: Mon Aug 02, 2021 8:13 am

SolarWinds Professional Questions + Answers

Post by answerhappygod »

Question 1 ( Topic 1 )
The data center team requires that they be alerted if any of the servers in a remote site go down. However, they do NOT want to receive alerts when the remote site connection goes down. Which two configuration steps should you take within your network management system (NMS) to meet these requirements? (Choose two.)
A. set up alerts on server status
B. set up alerts on the remote connection status
C. set each of the servers as dependencies for each other
D. set up the remote connection as a dependency for each of the servers
E. set up alerts on the remote router status


Answer : AD

Question 2 ( Topic 1 )
What is an advantage of using SNMPv2c over using SNMPv1?
A. username parameter
B. get bulk command
C. get next command
D. 32 bit counters
E. authentication and encryption


Answer : B

Question 3 ( Topic 1 )
Which two variables are used in the calculation of Percent Utilization? (Choose two.)
A. configured bandwidth
B. packets per second
C. buffer overruns
D. interface discards
E. bits per second


Answer : AE

Question 4 ( Topic 1 )
Due to a server crash, you had to move Orion to a new server with a new IP address. Which two changes should you make to ensure that Orion functions properly from the new server and IP address? (Choose two.)
A. update the access control lists (ACLs) that restrict management protocols
B. change the IP address specified in the snmpd. conf file on the Orion server
C. updates the source address for Net Flow packets exported to Orion
D. notify ARIN of the Orion server's new IP address
E. update the destination IP address for Syslog and SNMP traps on your managed devices


Answer : AE

Question 5 ( Topic 1 )
You are monitoring your Internet connection, and your ISP has guaranteed512 Kbps.
Historical data shows that your connection speed holds at 256 Kbps for long periods of time, but never exceeds this speed. What does this indicate?
A. the ISP has misconfigured the link.
B. the WAN router is misconfigured.
C. the NAT table is overloaded.
D. QoS is dropping low priority traffic.


Answer : A


Question 6 ( Topic 1 )
Your current deployment has multiple Orion NPM servers monitoring multiple locations from a single site. This is producing inaccurate data and high WAN bandwidth utilization. What are the two most efficient ways to address this issue? (Choose two.)
A. deploy Orion NPMat each remote location
B. deploy Orion Enterprise Operations Console
C. deploy an additional Orion Poller
D. deploy an additional Orion Web Server
E. deploy an Orion Hot Standby


Answer : AB

Question 7 ( Topic 1 )
How does the Orion Universal Device Poller (UnDP) monitor a device's statistics that are Not included in the standard Orion NPM MIB database?
A. by manually associating the device'sOID to Orion
B. by keeping a copy of the device's MIB on the Orion NPM Server
C. by automatically searching the common MIB repositories and updating Orion
D. by manually compiling the MIB into the Orion MIB database
E. by manually compiling the OID into the Orion MIB database


Answer : A

Question 8 ( Topic 1 )
Which protocol should a network engineer enable on routers and switches to collect utilization statistics?
A. ICMP
B. SNMP
C. SMTP
D. WMI


Answer : B

Question 9 ( Topic 1 )
A network engineer is enabling SNMP on their network devices and needs to ensure it will use message integrity. Which version of SNMP should they use?
A. SNMPv1
B. SNMPv2c
C. SNMPv3
D. SNMPv4


Answer : C

Question 10 ( Topic 1 )
A network engineer notices the Syslog server's database is growing significantly in size due to the large number of devices sending Syslog messages. What should the engineer do to control database growth?
A. configure the Syslog server to discard unwanted messages
B. configure the devices and the Syslog server to use TCP-based Syslog
C. configure the devices and the Syslog server to use SNMPv3
D. configure the Syslog server to capture SNMP traps instead of Syslog


Answer : A


Question 11 ( Topic 1 )
You have recently implemented a VoIP infrastructure within the company network. You are receiving trouble tickets indicating calls are dropping between their
New York and San Francisco offices. Which two IP service level agreement (SLA) measurements should you use to identify the cause of the issue?
A. latency
B. SIP
C. NetFlow
D. available bandwidth
E. jitter


Answer : AE

Question 12 ( Topic 1 )
Which two performance metrics can be affected by proper QoS implementation? (Choose two.)
A. jitter
B. shaping
C. marking
D. queuing
E. latency


Answer : AE

Question 13 ( Topic 1 )
Which network protocols are used by Solar Winds products during network discoveries?
A. ICMP and SMTP
B. DHCP and TFTP
C. PPTP and IMAP
D. ICMP and SNMP


Answer : D

Question 14 ( Topic 1 )
Which two management protocols should you use to measure the effectiveness of your QoS implementation? (Choose two.)
A. Syslog
B. SNMP
C. NetFlow
D. WMI
E. SSHv2


Answer : BC

Question 15 ( Topic 1 )
Which management protocol should you use to analyze network traffic in and out of a router interface?
A. WMI
B. Syslog
C. IP service level agreement (SLA)
D. sFlow


Answer : D


Question 16 ( Topic 1 )
Users are complaining that a network connection is slow. How should SNMP be used to verify performance of the interface?
A. verify bandwidth usage via if InOctets
B. verify status via the if Table
C. verify that SNMP agent is responding
D. verify the performance via if Speed


Answer : A

Question 17 ( Topic 1 )
Orion NPM is monitoring the performance of DS-3 utilizing standard MIBs in the ifTable. Occasionally, the reported traffic rates for this interface spike well above45 Mbps. What is the most likely cause?
A. heavy network traffic
B. carrier misconfiguration
C. counter rollovers
D. database issues


Answer : C

Question 18 ( Topic 1 )
Orion NPM is using SNMP to poll a routerand track interface traffic rates. The data are Collected every 5 minutes, and the most recent values collected for a specific interface are 1,000,000 and 2,000,000 octets. What is the approximate average rate of traffic for this interface?
A. 1 Kbps
B. 3 Kbps
C. 16 Kbps
D. 26 Kbps


Answer : D

Question 19 ( Topic 1 )
When using a network management system (NMS) to monitor network interfaces on a router, you notice that statistics are wrong after an interface card is physically removed from the device. What has most likely caused this problem?
A. interface re-indexing
B. device configuration
C. counter rollovers
D. access lists


Answer : A

Question 20 ( Topic 1 )
Which two reporting requirements should you consider when specifying data roll-up settings for a network management system (NMS)? (Choose two.)
A. data encryption
B. data format
C. data granularity
D. monitoring coverage
E. data retention


Answer : CE


Question 21 ( Topic 1 )
Which advantage do SNMP traps and Syslog have over SNMP polling?
A. reliability of event detection
B. ability to poll events in real-time
C. ease of configuration
D. speed of event detection


Answer : D

Question 22 ( Topic 1 )
How can you use a network management system (NMS) to ensure service level agreement (SLA) parameters are realistic for your environment?
A. increase data collection period
B. configuredata summarization
C. reducedata retention period
D. baseline network performance


Answer : D

Question 23 ( Topic 1 )
Your service level agreement (SLA) dictates that you must be able to notify the appropriate parties when systems are down for over2 minutes and report on data for the last120 days. Your network management system (NMS) has been configured to collect status every 10minutes and summarizes and retains data for 90 days. Which two settings should you change in the NMS to meet the business requirements? (Choose two.)
A. increase data retention to 120 days
B. configure status polling to occur every5 minutes
C. summarize hourly data into weekly data every 120 days
D. configure status polling to occur every minute
E. summarize hourly data into weekly data every 90 days


Answer : AD

Question 24 ( Topic 1 )
What should you do to track whether a new configuration has alleviated slow network performance?
A. compare ICMP availability before and after the change
B. compare application responsiveness before and after the change
C. monitor the affected devices for stability
D. monitor bandwidth utilization on affected interfaces


Answer : B

Question 25 ( Topic 1 )
The IT budgeting department has asked you for reports that will help them better plan for increases in monthly recurring costs. Which report should you set up to help the IT udgeting department meet this objective?
A. router inventory
B. WAN interface utilization
C. LAN interface utilization
D. available switch ports


Answer : B


Question 26 ( Topic 1 )
IT management wants to know how they can lower their total power consumption by consolidating equipment and shutting off unnecessary equipment. Which type of report can you create to help them plan for this?
A. bandwidth utilization
B. available switch ports
C. router CPU utilization
D. total NetFlow endpoints


Answer : B

Question 27 ( Topic 1 )
The IT planning department has asked for a report to help them understand when they need to implement IPv6. Which report would offer them the greatest amount of relevant information?
A. unique NetFlow exporters
B. DHCP server CPU utilization
C. number of subnets
D. IP address utilization trends


Answer : D

Question 28 ( Topic 1 )
You are planning a network management implementation where the network has several low bandwidth WAN links. Which two network management protocols are most likely to cause heavy traffic on WANs and should therefore be considered carefully before deployment? (Choose two.)
A. Syslog
B. SSH
C. SMTP
D. NetFlow
E. ICMP


Answer : AD

Question 29 ( Topic 1 )
Which two sources provide detailed visibility into router interface traffic? (Choose two.)
A. SNMP statistics
B. SNMP traps
C. NetFlow
D. Syslog
E. CDP


Answer : AC

Question 30 ( Topic 1 )
A network engineer is planning to deploy a network management system (NMS) to monitor a network. Which two UDP ports should be enabled in router access control lists and firewalls so the NMS can effectively monitor devices? (Choose two.)
A. 160
B. 161
C. 162
D. 163
E. 164


Answer : BC
Join a community of subject matter experts. Register for FREE to view solutions, replies, and use search function. Request answer by replying!
Post Reply