Please answer the theoretical question marked in yellow is more important than value calculations. Thank you

[answerhappygod]

Please answer the theoretical question marked in yellow is more
important than value calculations. Thank you

Please Answer The Theoretical Question Marked In Yellow Is More Important Than Value Calculations Thank You 1 (94.54 KiB) Viewed 41 times

ID B 1 X Paste х A A A Paragraph Styles Editing Dictate Editor Reuse Files A A - Aa Undo Font Clipboard CE La report Styles Voice Editor Reuse Files ETICS Experiment 8 Transient Circuit Analysis Objectives: 1. To perform transient analysis of a 1st order RC circuit 2. To perform transient analysis of a 2nd order RLC circuit Part I: Transient Analysis of RC Circuit t=0 w R CV Figure 1: RC series circuit Table 1: Vc Transient response of RC circuit 0 0.1 0.05 0.15 Time (ms) 0.2 0.25 0.3 0.4 0.5 0.35 V. (Simulation) V. (Measurement) Simulated and Measured Transient Voltage Responses ول P time in seconds

EE-271 Lab Report Electrie Circui Answer the following questions 1. What is the theoretical value of the time constant t of the circuit in Fig. 1? 2. Explain how to calculate the time constant from the Vc vs. time curves (simulation and hardware). Comment on any difference between them. 3. If you apply a square wave input with frequency IMHz, explain whether this is suitable for measuring the time constant of the circuit and why? Part II: Transient Analysis of RLC Circuit =0 + VR - + mm Figure 2: Series RLC circuit Table 2: Ve Transient response of RLC circuit Time (ms) 0 0.05 0.1 0.15 0.2 0.25 0:3 0.35 0.4 0.5 V. (Simulation) V. (Measurement

Electric Circuits 71 Lab Report Simulated and Measured Transient Voltage Responses Vc time in seconds Answer the following questions 1. What is the type of the transient response? What are the theoretical values of the damping factor a and the oscillation frequency od? 2. Using the measured Ye values, estimate these factors directly from the waveform plots. Comment on any difference between the values. 3. When the resistor is set to 10k , what is the type of the transient response? Explain why?