Please ASAP..... I will Rate and Like you. Course: Acquisition & Microcontrollers in Biomedical Engineering

[answerhappygod]

Please ASAP..... I will Rate and Like you.
Course: Acquisition & Microcontrollers in Biomedical
Engineering

Please Asap I Will Rate And Like You Course Acquisition Microcontrollers In Biomedical Engineering 1 (32.95 KiB) Viewed 67 times

Question 33 While using ARDUINO UNO to read from a 5V sensor, the analog read ( has a count value of 512. What is the voltage applied on the pin? Not yet answered Marked out of 1.67 a 104 V O b. 3.75 V Oc 42.3 V O d. 2.5 V P Flag question Question 34 To access the BANK1 in the memory: Not yet answered Marked out of 1.67 a. RPO should be set to o Ob. None of these Oc RP1 should be set to 1 O d. RPO should be set to 1 Flag question Question 35 What does this part of ARDUINO sketch do?:void setup() { pinMode (4, OUTPUT);} Not yet answered Marked out of 1.67 O a. This sets up pin to be output b. This sets up pin 4 to send a signal Oc This sets up pin 4 to be analog output O d. This sets up pin 4 to be digital Flag question Question 36 The instruction cycle time of a microcontroller with 50MHz clock frequency is: Not yet answered Marked out of 1.67 O a 0.11 us . O b. 0.08 us Oc. 1.22 us P Flag question O d. 0.04 us