Question 1B (TOTAL 25 MARKS) The continuous beam shown in Figure 1B is constructed using a single hot-rolled I section 3

[answerhappygod]

Question 1B (TOTAL 25 MARKS) The continuous beam shown in Figure
1B is constructed using a single hot-rolled I section 360UB50.7.
The properties of the section are shown in Table 1B Table 1B
Dimension and properties of 410UB59.7 d 406 mm fyf 300 Mpa Iy 12.1
X 106 mm4 bf 178 mm fyw 320 MPa Zy 135 x 103 mm3 tf 12.8 mm Ag 7640
mm2 Sy 209 x103 mm3 d1 381 mm Ix 216 x 106 mm4 ry 39.7 mm tw 7.8 mm
Zx 1060 x 103 mm3 J 337x103 mm4 rx 168 mm Sx 1200 x 103 mm3 Iw 467
x109 mm6 r1 11.4 mm The point loads on the beam, P, consists of a
concentrated permanent load (G) of 100kN (including allowance of
self-weight) and a concentrated live load (Q) of 200kN. The UDL on
the beam, W, consist of a uniformly distributed self-weight of
30kN/m and a uniformly distributed live load 24kN/m. The beam is
bent about the major axis and has full lateral restraint. Show,
using plastic analysis that the section is either suitable or
unsuitable to carry the applied loads