Write a word address program in absolute mode to drill the holes shown on the design given below. Use CNC tool and opera

[answerhappygod]

Write A Word Address Program In Absolute Mode To Drill The Holes Shown On The Design Given Below Use Cnc Tool And Opera 1 (35.77 KiB) Viewed 10 times

Write a word address program in absolute mode to drill the holes shown on the design given below. Use CNC tool and operations sheet given. Linear Feed is 250 mm/min Use tool size compensation codes (H4) as well as define units in mm. Thickness of the workpiece is 20 mm. The holes are all the same size (except for the holes in the middle) 20 mm deep (depth) and are drilled using peck drilling technique with a peck of 2mm and a retract value of 1 mm. Use tool 3 Spot Drill (15 mm) Diameter & depth of the hole is 10 mm for the holes in the middle (shown in blue) The holes are equal to the Tool 2 diameter 10mm. Write the coordinates of all the holes before writing the CNC program. Section AA A O O O O M8 x 1.25