Check the possibility of turning with a carbide indexable insert tool a steel cylinder M, with vc m/min, f mm with a too

[answerhappygod]

Check the possibility of turning with a carbide indexable insert
tool a steel cylinder M, with vc m/min, f mm with a tool with
entering angle χº. still knowing that the blank is a 3” circular
section billet and the diameter of the finished part must be DA mm,
and which must be performed only one pass. The machine available is
a PM kW power lathe nominal and η of yield. If machining is
possible, suggest a change to the machining parameters. machining
to increase productivity that allows exploiting all the power
availability of the machine in question. If machining is not
possible, suggest a change of machining parameters. machining that
makes it possible to perform the machining of the part.