TASK 2. Based on the initial data presented in the table, determine the tolerances limit deviations of the hole and shaf

[answerhappygod]

Task 2 Based On The Initial Data Presented In The Table Determine The Tolerances Limit Deviations Of The Hole And Shaf 1 (44.67 KiB) Viewed 24 times

TASK 2. Based on the initial data presented in the table, determine the tolerances limit deviations of the hole and shaft; the largest, smallest, probability gaps (tensions) and compare them with each other, give a graphical image of the landing; write down the numerical designation of the landing, the fields of tolerance of the hole and shaft. Variant dmax, mm 2 Nominal size, mm 166 Dmax , mm 166,084 Dmin , mm 166 dmin , mm 165,916 29 166