Design the progam using the M340plc for the process of lling the tank with water. The design should include start/stop

[answerhappygod]

Design the progam using the M340plc for the process of lling the
tank with water. The design should include start/stop circuit
to start the pump using direct on line (DOL) starter. In the
design, use low level and high level sensor to monitor the ow rate
and run valve for supplying the water to the consumer mains. The
design should avoid over ow and low level at all times. Show the
possible schematic using M340plc in the desgin.
(c) Design the graphics section using the operator screen for
the part above.