- Lo E An Input R T 1 Au T Is Applied To The System Where The Function U T Is The Unit Step Function It Is Desire 1 (26.01 KiB) Viewed 10 times
- Lo E An Input R T 1 Au T Is Applied To The System Where The Function U T Is The Unit Step Function It Is Desire 2 (39.4 KiB) Viewed 10 times
- Lo E An Input R T 1 Au T Is Applied To The System Where The Function U T Is The Unit Step Function It Is Desire 3 (26.79 KiB) Viewed 10 times
LO (e) An input r(t) = 1.Au(t) is applied to the system, where the function u(t) is the unit step function. It is desired that the steady-state error, ess < 0.1B. Determine the minimum value of K that would satisfy the design requirement. [6 marks]
16 marks The transfer functions of the control system shown in Figure Qla are as follows: Gc(S) = K (s + 3)2 (s + 5) (s + 1)(s + 4) Gp(s) ) and H(S) = 1. R(s) 10 7 E(S) e(t) Gc(s) Gp(s) C(s). c(1) HS) Figure Qla 11 15
Replace the letters A - F (highlighted in Yellow) with the numerical computation generated from the pre-assessment activity. For example, if A = 1 and B = 2 then 3A = 31, AB = 12, and A.B = 1.2. = =