Task 2 A solid shaft with diameter D mm and Lmm long is supported between two bearings at the ends as shown in Figure 2.

[answerhappygod]

Task 2 A Solid Shaft With Diameter D Mm And Lmm Long Is Supported Between Two Bearings At The Ends As Shown In Figure 2 1 (41.03 KiB) Viewed 9 times

Task 2 A solid shaft with diameter D mm and Lmm long is supported between two bearings at the ends as shown in Figure 2. The shaft is to transmit a torque of T Nm and a stationary vertical load of PKN is acting at the centre of the beam. Take ay = 380 MPa. (1) Find the Bending stress and shear stress due to stress-induced, (ii) Evaluate the principal stress acting at the centre of the beam; (iii) Determine the factor of safety for the Principal stresses obtained based on Tresca theory, (iv) Determine the factor of safety for the principal stresses obtained based on Von Mises - Henky theory. P (kN) 140 T (Nm) 300 L(mm) 740 D (mm) 60 Р Т. D L mm Figure 2