UHB EE 203: Electronics I Design Project - 212 Design the transistor amplifier shown in the following Figure to be biase

[answerhappygod]

Uhb Ee 203 Electronics I Design Project 212 Design The Transistor Amplifier Shown In The Following Figure To Be Biase 1 (72.25 KiB) Viewed 55 times

UHB EE 203: Electronics I Design Project - 212 Design the transistor amplifier shown in the following Figure to be biased at IC-1 mA. Clearly show/justify your calculations and component selection to determine its voltage gain. Assume B = 100 Assume 1) Verify your design using a MULTISIM or Pspice simulation. VC = 1/3 VCC VCC10V RC -O VC. RBB vaig VB. 2) If vsig is a triangle waveform, determine the maximum amplitude that vsig can have? Show your calculation. 3) Check to see if a vsig having this amplitude will indeed be valid for active mode of operation. Show and justify your results. 4) Run a simulation using the circuit of the above figure. Use the DC biasing arrangement you designed in part a) and a 10 Hz sinusoidal vsig with amplitude close to the one you calculated earlier in c). Plot the input and output waveforms. 5) Increase vsig to four times its original amplitude and run another simulation. What do you observe? Comment on and justify your results. 6) Write a report on your solution. You should clearly mention all the steps. Include the MULTISIM/Pspice circuit diagram of your simulation circuit. Other Information: Include any hand calculations that you perform to verify your design.