Question 8 Figure 3 below shows a network set up for Vulcan Fire Services. As the network administrator for the company

[answerhappygod]

Question 8 Figure 3 Below Shows A Network Set Up For Vulcan Fire Services As The Network Administrator For The Company 1 (84.19 KiB) Viewed 74 times

Question 8 Figure 3 below shows a network set up for Vulcan Fire Services. As the network administrator for the company you're required to configure all the network devices. Connection to Si has the following parameters and configuration commands: Hostname. Banner, Interface description, Passwords and IP address, subnet mask default gateway to cometan se conecta a tanto Figure 3. FO 192.168.10.17/20 Fon Fo/1551 FO/17 FO/16 FO/18 FO 10/2 Fors FO/S FOVA FO/ FO/6 192.168.10.19/28 Fo/a FO/1 FOV FO/3 192.168.10.18/28 FON a) Write down the commands necessary to configure the S2 and 53 switches respectively using all the parameters in S11 b) Verify the MAC address table for each switch by writing down the necessary commands

Question 8 Figure 3 below shows a network set up for Vulcan Fire Services. As the network administrator for the company you're required to configure all the network devices. Connection to Si has the following parameters and configuration commands: Hostname, Banner, Interface description, Passwords and IP address, subnet mask, default gateway Switchen Switch#config t Switch(config) thostnane si 51(config)#enable secret todd 51(config)#int fe/15 51(config-if)#description Ist connection to 53 S1(config-if)#int fe/16 51(config-if)#description 2nd connection to s3 51(config-if)#int f0/17 51(config-if)#description 1st connection to s2 51(config-if) wint fo/18 51(config-if)#description 2nd connection to s2 51(config-if)#int fe/8 51(config-if)"desc Connection to IVR 51(config-if)#line con e 51(config-line) password console 51(config-Line)#login 51(config-line) #line vty e 15 S1(config-line) #password telnet 51(config-line) #login 51(config-line) 1nt vlan 1 51(config-if)#ip address 192.168.10.17 255.255.255.24e 51(config-if)#no shut 51(config-if)#exit s1(config) #banner motd #this is ny si switch 51(config)#exit Sl#copy run start Destination filename startup-config)? [enter] Building configuration...