Page 1 of 1
Write a word address program in absolute mode to profile mill the contour given below. Use CNC tool and operations sheet
Posted: Sun May 15, 2022 9:11 pm
by answerhappygod
- Write A Word Address Program In Absolute Mode To Profile Mill The Contour Given Below Use Cnc Tool And Operations Sheet 1 (31.34 KiB) Viewed 39 times
Write a word address program in absolute mode to profile mill the contour given below. Use CNC tool and operations sheet given. Linear Feed is 250 mm/min and circular feed is 70 mm/min. Use tool compensation codes (H2/D2) as well as define units in mm. Thickness of the workpiece is 5 mm. Use tool 3 to drill a hole in the center of the workpiece along its thickness. The hole is equal to the Tool 2 diameter of 10mm. Use the cutting parameters shown in the table below. Hint: center point of the hole is located at point (50, 25) 80 50 35 . R 17.5 R 15 30 O 020 050