- 1 (43.61 KiB) Viewed 48 times
1) Insert the key into the switch and rotate it from OFF → ON to enable the system. The green Power lamp will illuminate. If the green Power lamp is off, check the connection to the system's source of power. If the lamp is on, 2) Remove the key from the switch. TO STARTUP THE DRILL SYSTEM: Initial Status of Indicator Lamps: DRILL ACTIVE: Oir POWER: On LOCKOUT: Of READY: Ofr OVERLOAD: OIT WATER ON OF Low WATER: Off PRESSURE 1) Press the to The lamp will illuminate. 2) Press the to The lamp will illuminate. 3) Press the to The lamp will illuminate. Final Status of Indicator Lamps after the drill is started: POWER: READY: WATER ON: LOCKOUT: OVERLOAD: LOW WATER: PRESSURE DRILL ACTIVE:
TO SHUTDOWN THE DRILL SYSTEM (to the initial state when the key was first switched on): Initial Status of Indicator Lamps: WATER ON: LockOur: Low WATER: POWER: READY: DRILL ACTIVE: OVERLOAD: PRESSURE 1) Press the to The _lamp will turn off 2) Press the to The lamp will turn off. If the doesn't 3) Press the to The lamp will turn off. Final Status of Indicator Lamps after the drill system is shutdown: POWER: On READY: Ofr WATER ON: Off LOCKOUT: OF OVERLOAD: Off Low WATER: Off PRESSURE DRILL ACTIVE: Of EMERGENCY STOP: Pressing the EMERGENCY STOP button will Status of Indicator Lamps after EMERGENCY STOP is pressed: POWER: LOCKOUT: DRILL ACTIVE: READ: OVERLOAD: WATER ON: Low WATER: PRESSURE In order to restart the system after EMERGENCY STOP is pressed, you must
the and SYSTEM FAULT - MOTOR OVERLOAD: A MOTOR OVERLOAD occurs if the drill motor draws too much current for an extended time. When an overload condition is detected, the lamp will illuminate, and lamps will turn off Status of Indicator Lamps after an OVERLOAD occurs: POWER: WATER ON: DRILL ACTIVE: Lockout: PRESSURE In order to restart the drill after an OVERLOAD occurs: 1) Press the lamp will turn off, and lamp will illuminate. If the lamp doesn't turn off, you must READY: OVERLOAD: Low WATER: to The the 2) The drill can now be restarted by pressing the SYSTEM FAULT - Low WATER PRESSURE: If low water pressure is detected while the system is operational, DRILL ACTIVE: Status of Indicator Lamps after Low WATER PRESSURE is detected: POWER: READY: WATER ON: LOCKOUT: LOW WATER: PRESSURE In order to restart the drill after Low WATER PRESSURE is detected, OVERLOAD: SYSTEM FAULT - HIGH DRILL-BIT TEMPERATURE: Although the water spray is meant to help cool the bit while the drill is in use, the temperature of the drill bit may increase to the point that the bit is not safe to touch during normal operation. In order to prevent the operator from being exposed to this potential hazard, if the temperature of the bit becomes too hot during operation, the system will