Review Questions The Graph Below Is The Applied Voltage X Axis And Resulting Current Y Axis Place The Labels From 1 (29.58 KiB) Viewed 43 times
Review questions: the graph below is the applied voltage (x-axis) and resulting current (y axis). Place the labels from this list onto the graph: reverse bias region, forward bias region, and turn- on voltage. 10 Vp Discussion: Introduction to logic gates Procedure for the group: Refer to 'Introduction to TTL Logic Gates?t This lab will use a 7404 chip (inverter) 1. Construct the circuit in Figure below on your breadboard. VCC VCC 5.0V 5.0V S1 Pin 14 Pin 1 Pin 2 Pin7 R1 3300 LED1 ị 7404N
2. A switch is used to test the operation of the gate. Using the LED as an indicator, fill in the table below. Using the multimeter, measure the value of the voltage at the output of the logic gate for each condition. Remember: a 'O' is zero voltage, *1' is +5 voltsé ܒܐ Pin 2 Voltage le oe le ܒܢ tt 3. If the bit sequence shown on the table below was applied to the input of the circuit above, what would you expect the output bit sequence to be? ܒܢ Pin 14 Pin 24 02 le le 02 0 le 02 ܒܪ le e 4. A TTL system does not appear to be working correctly. A technician takes the readings from a 7404 chip (NOT Gate) and provides the data in the table below. Is this chip working correctly? ܒܕܐ 15 LLLLtttttttt Pin 14Pin 24 02 le le le ole le le oele le lele 0 ole lele le jele 0 le ole ܢܢ1 ܒܕܐ ܢ1
5. What is the range of the following logic voltage thresholds (from lecture): + HIGH: V to 5V INVALID: V to __V LOW: OV to ve
Join a community of subject matter experts. Register for FREE to view solutions, replies, and use search function. Request answer by replying!