Initial wire of 3105 aluminum alloy with diameter 5 mm needs to be reduced in diameter down to 3.1 mm by cold drawing. F

[answerhappygod]

Initial Wire Of 3105 Aluminum Alloy With Diameter 5 Mm Needs To Be Reduced In Diameter Down To 3 1 Mm By Cold Drawing F 1 (52.84 KiB) Viewed 45 times

Initial wire of 3105 aluminum alloy with diameter 5 mm needs to be reduced in diameter down to 3.1 mm by cold drawing. Final wire should be able to elongate befor break by 5.5%. Properties of cold-worked 3105 aluminum alloy are shown in figure below. Describe how it can be done. Effect of percent cold work on the properties of 3105 aluminum alloy 250 25 Tensile Strength (MPa) Yield Strength (MPa) 200 20 150 Strength (MPa) 100 50 0- 0 20 Elongation (%) 40 60 80 Percent Cold Work 15 10 5 0 Elongation (%)