- Assignment 2 Sheet Metal Tapered Wall Fray Objective To Perform Cutting And Forming Processes On A Sheet Metal To Produ 1 (37.74 KiB) Viewed 36 times
Answer only: (3),(4),(5),(6).
ASSIGNMENT-2 Sheet metal tapered wall fray Objective: To perform cutting and forming processes on a sheet metal to produce a tapered wall fray with dimensions of 50 X 40, 70cm Length, and 25cm hight at the end side with handle holes diameter 20mm, and spot welding at both sides. 00 handle hole diameter 20mm Instructions • List all the tools used in practice regarding Marking-Out Tools (name, sketches, objective and application) • List all the tools used in practice regarding Sheet Metal Work (name, sketches, objective and application) • Show practically how to transfer a specific drawing, measurements, and shape onto a sheet of metal. • Write down the steps to produce a tapered wall tray with dimensions of 50 x 40, 70cm Length, and 25cm hight at the end side, as it mentioned in the figure above, using a sheet metal thickness of imm. • Mention the tool used for each step. • Show the practical diagrams, sketches for each step. . Anyone copying will be given zero. Notice That: A practical sketch should be added for every single step during the processes.