You are troubleshooting a site-to-site VPN issue where the tunnel is not establishing. After issuing the debug crypto is

[answerhappygod]

You are troubleshooting a site-to-site VPN issue where the tunnel is not establishing. After issuing the debug crypto isakmp command on the headend router, you see the following output. What does this output suggest?
1d00h: ISAKMP (0:1): atts are not acceptable. Next payload is 0
1d00h: ISAKMP (0:1); no offers accepted!
1d00h: ISAKMP (0:1): SA not acceptable!
1d00h: %CRYPTO-6-IKMP_MODE_FAILURE. Processing of Main Mode failed with peer at 10.10.10.10

A. Phase 1 policy does not match on both sides.
B. The transform set does not match on both sides.
C. ISAKMP is not enabled on the remote peer.
D. There is a mismatch in the ACL that identifies interesting traffic.