A network engineer has set up VRF-Lite on two routers where all the interfaces are in the same VRF. At a later time, a new loopback is added to Router 1, but it cannot ping any of the existing interfaces. Which two configurations enable the local or remote router to ping the loopback from any existing interface? (Choose two.)
A. adding a static route for the VRF that points to the global route table
B. adding the loopback to the VRF
C. adding dynamic routing between the two routers and advertising the loopback
D. adding the IP address of the loopback to the export route targets for the VRF
E. adding a static route for the VRF that points to the loopback interface
F. adding all interfaces to the global and VRF routing tables AB
A network engineer has set up VRF-Lite on two routers where all the interfaces are in the same VRF. At a later time, a n
-
answerhappygod
- Site Admin
- Posts: 899604
- Joined: Mon Aug 02, 2021 8:13 am
A network engineer has set up VRF-Lite on two routers where all the interfaces are in the same VRF. At a later time, a n
Join a community of subject matter experts. Register for FREE to view solutions, replies, and use search function. Request answer by replying!