Scenario - An administrator is trying to ping and telnet from Switch to Router with the results shown below: For this

[answerhappygod]

Scenario -

An administrator is trying to ping and telnet from Switch to Router with the results shown below:

For this question we only need to use the show running-config command to answer all the questions below:

Router>enable -

Router#show running-config -

Which will fix the issue and allow ONLY ping to work while keeping telnet disabled?

Scenario An Adm 1 (7.77 KiB) Viewed 50 times

Scenario An Adm 2 (89.86 KiB) Viewed 50 times

Scenario An Adm 3 (63.14 KiB) Viewed 50 times

Scenario An Adm 4 (188.87 KiB) Viewed 50 times

Scenario An Adm 5 (95.08 KiB) Viewed 50 times

Scenario An Adm 6 (228.43 KiB) Viewed 50 times

A. Correctly assign an IP address to interface fa0/1
B. Change the ip access-group command on fa0/0 from "in" to "out"
C. Remove access-group 106 in from interface fa0/0 and add access-group 115 in.
D. Remove access-group 102 out from interface s0/0/0 and add access-group 114 in
E. Remove access-group 106 in from interface fa0/0 and add access-group 104 in