(a) A single angle section is used as a tension member in a rooftruss. It is connected to gusset plates at each end by filletwelds. Use the member capacity tables of your P363 to select asuitable angle in S275 steel, if the tension due to Ultimate LimitState factored loads is 180kN. [5 marks] (b) Design a suitablefillet weld detail according to the requirements of Eurocode 3. Youmay NOT use the pink pages of P363 to assist in your weld design,but should use the appropriate weld strength clauses of EN1993-1-1(Eurocode 3) instead. [10 marks]
(b) Design a suitable fillet welddetail according to the requirements of Eurocode 3. You may NOT use the pink pages of P363 to assist in your welddesign, but should use the appropriate weld strength clauses ofEN1993-1-1 (Eurocode 3) instead.
(a) A single angle section is used as a tension member in a roof truss. It is connected to gusset plates at each end by
-
answerhappygod
- Site Admin
- Posts: 899604
- Joined: Mon Aug 02, 2021 8:13 am
(a) A single angle section is used as a tension member in a roof truss. It is connected to gusset plates at each end by
Join a community of subject matter experts. Register for FREE to view solutions, replies, and use search function. Request answer by replying!