A E 63 O Bed Tie Plate 167woob Coslogose Surface Grind Mounting Plate 167wioof Be Sure 7 8 Hole Is In Position As Show 1 (54.47 KiB) Viewed 30 times
A E 63 O Bed Tie Plate 167woob Coslogose Surface Grind Mounting Plate 167wioof Be Sure 7 8 Hole Is In Position As Show 2 (59.16 KiB) Viewed 30 times
A E 63- O BED TIE PLATE 167WOOB COSLOGOSE SURFACE GRIND MOUNTING PLATE 167WIOOF -BE SURE 7/8 HOLE IS IN POSITION AS SHOWN WHEN WELDING PLATE IN PLACE SURFACE GRIND (TYPS 10- BED THE PLATE STWOOA SREGD TYPI WELDING NOTE "B" 3 RSW TO BE MADE ON VERTICALE OF EACH BED TIE PLATE AS SHOWN IN FRONT APRON 067W1000) AND REAR APRON (167100H) -TURLAR CONNECTOR 167000-5 SURFACE GRIND- 16 DRAWING SHOWS 4 FOOT BED BY ADDING 12 INCH SECTIONS 5 AND 6 FOOT BEDS ARE OBTAINED o MOUNTING PLATE- TWIDDE O MENTER NEXT ASSEM 167E103 PAIL STWOOD epp 46 E APRON NTWOOG 1/64 1/2 MALXA STROOK Vom SPESENST WEEP WELDS MT FROM THESE CORNERS WHEN WELDING FAILS TO TE PLATES TOOTJE MORE WELD RAILS WITH GROUND EDGES ON THE NODE ENCLOSING THE 2300/250 M WELDING NOTE KEEP WELDS FROM EDGES OF TE PLATES AT A AS SHOWN ON END VIEW ABOVE SECTION AA RAPRON WOO JOHNSON MACHINERY CO ASSEMING LAC HO CYATION baad 1670 100 238 Wing Reading
Name Part III Refer to the drawing (167E100) on the next page and answer the following questions. 1. Name the unit shown on the drawing. 2. Where is the drawing number located? 3. The scale of the drawing is 4. What is the next assembly?_ 5. How many individual parts make up the com- pleted unit? 6. Name the bed length of the unit shown. 7. What information is given on the slot welds? 8. What are the special instructions indicated in Note "A"? 9. The distance from the base of the unit to the top of the rails is Unit 17 Plug and Slot Welds 237 10. What special instructions are to be followed when welding the rails into place? A. B. 11. How many different types of welds are indicated? 12. The total width of the unit is 13. The width of the mounting plates is 14. What instructions are given concerning the hole positions on the mounting plate? 15. Welding Note "B" is concerned with
Join a community of subject matter experts. Register for FREE to view solutions, replies, and use search function. Request answer by replying!