- On An Oscilloscope The Channel 1 S Vertical Position Or Offset Control Allows You To Select One O A Change The Rang 1 (13.93 KiB) Viewed 53 times
On an Oscilloscope the channel 1's vertical position or offset control allows you to... Select one: O a. Change the Rang
-
answerhappygod
- Site Admin
- Posts: 899603
- Joined: Mon Aug 02, 2021 8:13 am
On an Oscilloscope the channel 1's vertical position or offset control allows you to... Select one: O a. Change the Rang
On an Oscilloscope the channel 1's vertical position or offset control allows you to... Select one: O a. Change the Range or 'Volts/div' used to display channel 1. O b. O c. O d. e. Adjust channel 1's zero volt 'ground' marker and resultant waveform up and down on the Scopes display. Add a DC offset voltage to the circuit under test. Move the entire display of the scope in the vertical direction. Finely tune the thickness of the lines used in channel 1's plot.