A car garage door and light are controlled remotely or directly by activating push-buttons. The garage system design is

[answerhappygod]

A Car Garage Door And Light Are Controlled Remotely Or Directly By Activating Push Buttons The Garage System Design Is 1 (79.54 KiB) Viewed 50 times

A car garage door and light are controlled remotely or directly by activating push-buttons. The garage system design is shown in the Fig.P1. Design an embedded system for this control mechanism (Block Diagram, Schematics Diagram, Flow Chart and Arduino Sketch or Program Code) with the following condition. ✓ A Remote control (example remote control HX1838 and IR Module) is used to: • Open / Close the rolling door of Car Garage using an electric motor • Switch ON the Lamps in the Garage Room There are 2 Push Button on the garage wall (one inside the garage room and one outside). They are used to open/close the garage rolling door. The garage rolling door is occupied two limit -switches, which are used to monitor the door position (fully opened ore fully closed). The rolling door is driven by an electric motor and is turned ON (to open to close the door) when it is activated and OFF when the limit switch is triggered. There are two additional Push Buttons and they are used to switch ON garage lamps from two different place. The Garage Lamp is turning OFF, if there is no any motion (any person) in the garage room and after 2 minutes the lamp is switched ON. A PIR Motion sensor is used to detect this motion. The PIR Sensor is set in re-trigger-able mode, preset the time is 2 minutes. CAR ENTRY PIR MOTION SENSOR ROLLING DOOR PUSH BUTTON GEARED AC MOTOR, 220V CAR GARAGE ROOM & WORKSHOP AREA LAMP CONTROL BOX Figure P1 : CAR GARAGE SYSTEM LAMP PUSH BUTTON EXIT DOOR/ ENTRY DOOR INTO MAIN HOUSE