- Plase Do That Ltspice 1 (213.31 KiB) Viewed 31 times
PLASE DO THAT LTSPICE
-
answerhappygod
- Site Admin
- Posts: 899603
- Joined: Mon Aug 02, 2021 8:13 am
PLASE DO THAT LTSPICE
PLASE DO THAT LTSPICE
6- Swap the emitter and collector points of the BJT. R1 R2 R 1 Ok B NPN Q1 V1 V2 с 5V 5V R3 1k Figure 6 Circuit Schematic for Forward Bias 7- Change Ri's value, measure le, Vez values and and insert them in Table 4. Table 4 R12 VBE VR2 IE 1B B 100k 10k 4k 0 8- Explain the difference of B values between three regions (forward, reverse and saturation). [Calculate the average value of B for each region] Table 4 8 comparison B Region Forward Bias Reverse Bias Saturation 9- Use LTspice, simulate each circuit you counducted at lab. Create Table 2, 3 and 4 with using Excel and fill it with your simulation measurements. Plot lc versus Vee and Ic versus ls with LTspice. Compare your simulation and experiment results. If there is a difference between your experiment and simulation reusits explain why.
6- Swap the emitter and collector points of the BJT. R1 R2 R 1 Ok B NPN Q1 V1 V2 с 5V 5V R3 1k Figure 6 Circuit Schematic for Forward Bias 7- Change Ri's value, measure le, Vez values and and insert them in Table 4. Table 4 R12 VBE VR2 IE 1B B 100k 10k 4k 0 8- Explain the difference of B values between three regions (forward, reverse and saturation). [Calculate the average value of B for each region] Table 4 8 comparison B Region Forward Bias Reverse Bias Saturation 9- Use LTspice, simulate each circuit you counducted at lab. Create Table 2, 3 and 4 with using Excel and fill it with your simulation measurements. Plot lc versus Vee and Ic versus ls with LTspice. Compare your simulation and experiment results. If there is a difference between your experiment and simulation reusits explain why.