Bending Members Introduction In This Assignment Your Objective Is To Design The Joist Members And The Beams Presented I 1 (30.64 KiB) Viewed 23 times
Bending Members Introduction In this assignment, your objective is to design the joist members and the beams presented in the first assignment. Joists and beams should be designed for shear, bending and serviceability conditions. Instructions • Complete this assignment individually. Produce a written report that includes calculations and necessary figures. Your instructor will assess your solution based on the following points: o Calculate the factored loads applied on the joist. O Calculate the serviceability loads applied on the joist. o Design the joists for shear and bending. o Check the joists for serviceability conditions. o Calculate the factored loads applied on the beam. o Calculate the serviceability loads applied on the beam. o Design the beam for shear and bending. o Check the beam for serviceability conditions. Note: You are free to assume any necessary information to complete the solution.
Marking Criteria Marks Marks will be allotted as follows: Calculate the factored loads applied on the joist. Calculate the serviceability loads applied on the joist. Design the joists for shear and bending. Check the joists for serviceability conditions. Calculate the factored loads applied on the beam. Calculate the serviceability loads applied on the beam. Design the beam for shear and bending. Check the beam for serviceability conditions. Total mark 5 10 5 5 10 / 50
5 m 2 1 A Column 4 m Beams B 4 m Roof 4 m External Walls
Join a community of subject matter experts. Register for FREE to view solutions, replies, and use search function. Request answer by replying!