a) You are expected to design circuit for the Wilkinson power divider in Microstrip technology. The designed power divid

[answerhappygod]

A You Are Expected To Design Circuit For The Wilkinson Power Divider In Microstrip Technology The Designed Power Divid 1 (55.32 KiB) Viewed 23 times

a) You are expected to design circuit for the Wilkinson power divider in Microstrip technology. The designed power divider must have equal power division output (-3 dB) and at least 10 dB isolation and return loss. Assume characteristic impedance, ZO is 50 ohm. Design Frequency / Centre Frequency (GHz) 3.5 Substrate Dielectric Constant (er) 4.50 Substrate thickness, h (mm) 0.813 Loss tangent (tan 8) i. S₁ (unit: magnitude dB) ii. S21 (unit: magnitude dB) iii. S31 (unit: magnitude dB) iv. S₂23 (unit: magnitude dB) v. Phase difference between Port 2 and Port 3 (unit: degree) 0.0020 Metallization 35 μm copper The solution of the given problem must be done, where calculations required be included. You must state expected results of: