- For Wye For Delta Vi 1316 11 Lo L 1 1312 L 6 5 Materials Equipment 1 Labvolt Power Supply 1 Labvalt Thr 1 (17.46 KiB) Viewed 55 times
- For Wye For Delta Vi 1316 11 Lo L 1 1312 L 6 5 Materials Equipment 1 Labvolt Power Supply 1 Labvalt Thr 2 (109.79 KiB) Viewed 55 times
- For Wye For Delta Vi 1316 11 Lo L 1 1312 L 6 5 Materials Equipment 1 Labvolt Power Supply 1 Labvalt Thr 3 (40.76 KiB) Viewed 55 times
below.
- For Wye For Delta Vi 1316 11 Lo L 1 1312 L 6 5 Materials Equipment 1 Labvolt Power Supply 1 Labvalt Thr 4 (23.58 KiB) Viewed 55 times
6.6 Circuit Diagrams Figure 6.1. Delta-Delta Transformer Bank Connection PRIMARY SIDE SECONDARY SIDE AI A6 12 4 15 VPH lelle VL T3 T1 VL T3 VPH A4 14 A: T2 0000000 As T2 0000000 9 10 ic A3 “SAFETY First" 208V SUPPLY 4 5 0-208 6 GENERAL RULE: Do not energize the circuit i unless you are told to do so by your instructor 3 Phase Source
6.7 Procedures 1. Connect the three-phase transformer as shown in the figure 6.1 2. Turn on the power supply. Gradually Increase the control knob so that the line currents will read .409A. The resistive load should be on its off position to have a zero load. 3. Open the resistive load using table below for purely resistive load TRANSFORMER SECONDARY LOADS TRIALS LOAD 1 LOAD 2 LOAD 3 1 300 ohms 300 ohms 300 ohms 2 600 ohms 600 ohms 600 ohms 3 1200 ohms 300 ohms 600 ohms 4 300 ohms 300 ohms 1200 ohms 4. Measure the Line and Phase voltages and complete table 6.1 for primary and secondary side 5. Measure the Line and Phase current and complete table 6.2 for primary and secondary side. 6. Return the current to zero and turn off the power supply.
6.8.1 Data and Results Primary Side Line Voltages Secondary Side Line Voltages Phase Voltages TRIAL Phase Voltages 1 2 3 4 Table 6.1 Comparison of voltages Primary Side Line current Secondary Side Line current Phase current TRIAL Phase current 1 2 3 4 Table 6.2 Comparison of current