The beam shown below is subjected to only two types of loads: live load WL = 0.7 k/ft, and dead load wo = 1.5 k/t. Based

[answerhappygod]

The Beam Shown Below Is Subjected To Only Two Types Of Loads Live Load Wl 0 7 K Ft And Dead Load Wo 1 5 K T Based 1 (52.11 KiB) Viewed 35 times

The beam shown below is subjected to only two types of loads: live load WL = 0.7 k/ft, and dead load wo = 1.5 k/t. Based on the ASCE 7-16 basic load combinations, determine the following: (1) maximum factored negative moment M. at support B (2) maximum factored negative moment Mu at support D (3) maximum factored positive moment Mu at section E (mid-span of DF) (4) maximum factored shear Vu at the immediately right side of section D A B E G A 32 ft H 16 ft + + + + 16 ft 16 ft Problem 2 In addition to distributed dead load, the continuous beam shown below is subjected to uniformly distributed. live load. Assuming that the load combination of 1.2D+ 1.6L governs, determine and show by figures the live load distribution patterns used to obtain the following required strength as design basis: (1) factored negative moment M. at support B (2) factored negative moment Mu at support D (3) factored positive moment Mu at the mid-span of AB (4) factored positive moment Mu at the mid-span of BC (5) factored shear Vu at the immediately left side of section D (6) factored shear Vu at the immediately right side of section D A B D E F गति Ar A 16 ft 16 ft