Use the graphical method to construct the shear-force and bending-moment diagrams for the beam shown. Let a=4.0 ft, b=9.

[answerhappygod]

Use The Graphical Method To Construct The Shear Force And Bending Moment Diagrams For The Beam Shown Let A 4 0 Ft B 9 1 (34.37 KiB) Viewed 47 times

Use The Graphical Method To Construct The Shear Force And Bending Moment Diagrams For The Beam Shown Let A 4 0 Ft B 9 2 (51.15 KiB) Viewed 47 times

Use The Graphical Method To Construct The Shear Force And Bending Moment Diagrams For The Beam Shown Let A 4 0 Ft B 9 3 (19.35 KiB) Viewed 47 times

Use The Graphical Method To Construct The Shear Force And Bending Moment Diagrams For The Beam Shown Let A 4 0 Ft B 9 4 (21.65 KiB) Viewed 47 times

Use the graphical method to construct the shear-force and bending-moment diagrams for the beam shown. Let a=4.0 ft, b=9.0 ft. c=5.0 ft, d=4.0 ft, w = 4.5 kips/ft and P = 36 kips. Construct the shear-force and bending-moment diagrams on paper and use the results to answer the questions in the subsequent parts of this GO exercise. B D E For this loading, calculate the reaction forces A, and E, acting on the beam. Positive values for the reactions are indicated by the directions of the red arrows shown on the free-body diagram below. (Note: Since A, = 0, it has been omitted from the free-body diagram.) D Le b Answers: Av kinn kips, Ey E,

Part 2 Determine the shear force acting at each of the following locations: (a) x = 0+ ft (i.e., just to the right of support A) (b)x= 4.0 ft (c) x = 13.0 ft (d) x = 18.0-ft (i.e., just to the left of D) (e) x = 18.0+ ft (i.e., just to the right of D) (f) x = 22.0-ft (i.e., just to the left of support E) When entering your answers, use the shear force sign convention. Answers: (a) V = i kips. (b) V = kips. (c) V = i kips. (d) V = i kips. (e) V = i kips. (f) V = i kips. i

Part 3 Use the graphical method to determine the bending moment acting at B (i.e., x 4.0 ft). When entering your answers, use the bending moment sign convention. Answer: MB-i kip-ft. eTextbook and Media Save for Later Attempts: 0 of 5 used Submit Answer Part 4 The shear-force diagram crosses the V-0 axis between points B and C. Determine the location x (measured from A) where V-0 kips Answer: ft. eTextbook and Ma

Calculate the maximum bending moment (i.e., either positive or negative) that occurs between points B and C. When entering your answers, use the bending moment sign convention. Answers: M = kip-ft. eTextbook and Media Save for Later Attempts: 0 of 5 used Submit Answer Part 6 Use the graphical method to calculate the bending moments at: (a) point C. (b) point D. When entering your answers, use the bending moment sign convention. Answers: (a) M- kip-ft. (b) M- kip-ft