You are the designer and asked to design an in-line speed reducer to satisfy given input-output conditions. In this resp

[answerhappygod]

You Are The Designer And Asked To Design An In Line Speed Reducer To Satisfy Given Input Output Conditions In This Resp 1 (76.66 KiB) Viewed 29 times

You are the designer and asked to design an in-line speed reducer to satisfy given input-output conditions. In this respect, the input power, Hin, input speed, niŋ, output speed, nout, the combined reliability, R, design life, N, the minimum factor of safety, ŋ, minimum material hardness requirements are all specified (all of these are given on an Excell file on the Moodle course site). Take F = 12.5 m. POWER nin nout,max nout, min [KW] rpm rpm rpm Take K* Material Thorough Factor of Overall Hardened Safety Reliability 0,99 HB 17,8 1980 192 190 2,85 340 GRADE-1 1,6 Input shaft A B L Output shaft X b-101 N₂ N3 Specify appropriate tooth numbers for each gear involved in the speed reducer to satisfy the input output requirements. y N₂ N5 5 [X][X] IXI C 3 E F IXI D b