Topic: Operational Amplifier Objective: i. To simulate and characterize the B.T circuits using MultisimLive. ii. To veri

[answerhappygod]

Topic Operational Amplifier Objective I To Simulate And Characterize The B T Circuits Using Multisimlive Ii To Veri 1 (9.87 KiB) Viewed 22 times

Topic: Operational Amplifier Objective: i. To simulate and characterize the B.T circuits using MultisimLive. ii. To verify the electronic circuit analysis based on theoretical study and simulations. Scope of work: 1. Determine the maximum and minimum gain for the amplifier shown in Figure 1. 50 k(3 1000 k 5.02 W -12V 2 Figure 1 2. Design an amplifier circuit using op-amp based on the following specification. Ther, test and verify it by simulation. Table 1 Group Group 6, 7, 8, 9, 10 1, 2, 3, 4, 5 Parameter Type inverting summing amplilier non-inverting summing amplifier Numbers of 2 input signals Gain Set to any, between 1 to 20 Observation on the output waveform for the following cases should be performed: Table 2 Case Input signal 1, V₂ Input signal 2, V₂ 1 DC DC 2 DC ac 3 DC ac (same frequency as V₁ 4 AC ac (different frequency to Vi) 3. Analyze the comparator circuit shown in Figure 2. Then, determire the ON ard OFF status of each LED according to the given input levels in Table 3. 107 Table 3 L1 L3 1V 5V 10 V DV 12 ܢܝܝܐ 1 SKO 3k3 { Vin 2 kil -LV Z Z -12 V Figure 2 12V I.I 12 W 1.2 L3 है। k62 Xxx 1 KO " 13 -.2V