Design a Traffic Light Controller (TLC) digital circuit which will operate in the following sequence: Red, Red, Red Yell

[answerhappygod]

Design A Traffic Light Controller Tlc Digital Circuit Which Will Operate In The Following Sequence Red Red Red Yell 1 (96.16 KiB) Viewed 43 times

Design a Traffic Light Controller (TLC) digital circuit which will operate in the following sequence: Red, Red, Red Yellow, Green, Green, Green, Yellow, Red, Red, Red, Yellow, Green, Green, Green, and repeat. The time of each state (Green or Red or Yellow) will be decided based on the clock cycle frequency (T=1/f). The sequence is shown in the below state diagram, design the Traffic Light Controller (TLC) using T flip- flops. 000 001 010 011 (R) (R) (R) (Y) 111 110 101 100 (Y) (G) (G) (G) U5 PLD1 구 clk Red Yell F Hz Grn Traffic Light Controller S1 VCC S2 5.0V S3 U4 TRAFFIC_LIGHT_SINGLE

(Note: Don't leave any cell without selecting either 1 or 0 in the truth table and K map.) • TA= . • TB= ♦ Present State ABC A+ 0000+ 0 0 0 1 0 0100+ 0 11 1+ 100 1 + 101 1+ 110 1 1 1 1 0 + Next state B+ C+ TB Red Yellow Green + 1 + 0 0 + 1 0 0 1 0 + + 0 + 0 + 1 1 + + 14 14 04 14 14 04 04 04 14 04 0 + 1 + 0 1 1 + 1 + 0 + 0 + 0 + 1 0 1 + 1+ 0 + 0 + 1 + 1 + 1+ 1+ 0 + 0 + 1+ 0 + 0 + 0 + 0 + BC 00 01 11 10 BC- 00 01 11 10 ΤΑ 0 + ♦ ◆ + 0 A A 1 + ◆ 1 Output ♦ + Tc 1 + 1 0 + 14 04 + 0 + 0 + 0 + 0 + 0 + 1+ 1+ 0 +

To= • Red= • Yellow= BC 00 01 11 10 BC 00 01 11 10 BC 00 01 11 S 10 0 + 0 + 0 ♦ + A A A 1 ♦ ◆ 1 + + ♦ ♦ 1 + + ◆

Yellow= ◆ 01 ♦ 11 10 ◆ Green= BC 00 01 11 10 Calculate the frequency of the clock if the Red signal should be ON for 30 seconds. f= 0.1 + Hz Please answer all parts of the question. Implement the circuit in Multisim. Upload your design circuit here(the Multisim circuit not a picture of it). . BC 8 00 0 0 O • ◆ A A 1 ◆ ◆ + 1 • ◆ •