TASK 2. Based on the initial data presented in the table, determine the tolerances limit deviations of the hole and shaf

[answerhappygod]

Task 2 Based On The Initial Data Presented In The Table Determine The Tolerances Limit Deviations Of The Hole And Shaf 1 (46.95 KiB) Viewed 12 times

TASK 2. Based on the initial data presented in the table, determine the tolerances limit deviations of the hole and shaft; the largest, smallest, probability gaps (tensions) and compare them with each other; give a graphical image of the landing; write down the numerical designation of the landing, the fields of tolerance of the hole and shaft Variant dmax mm Nominal size, mm 189 Dmax, mm 189,076 Dmin , mm 189,03 dmin, mm 188,97 30 189