- Please Use Ansys Workbench 1 (47.19 KiB) Viewed 50 times
please use ANSYS workbench
-
answerhappygod
- Site Admin
- Posts: 899604
- Joined: Mon Aug 02, 2021 8:13 am
please use ANSYS workbench
please use ANSYS workbench
8.10 The following rotor assembly consists of a rotor, a shaft, and a base. The assem Poisson's ratio v=0.3, and density p = 7850 kg/m2. The base of the assembly is bly components are made of structural steel with Young's modulus E = 200 GP fixed on the bottom. Suppose a harmonic pressure load of magnitude 100 N cm is applied to the side surface of the base as shown below. Using the FEA compute: The frequency response of the directional deformation on the w The first five natural frequencies and normal thodes et direction) of the cylindrical shatt surface under the given harmonoload bonded contact for contact regions 100 Load A rotor assembly Assembly front view (unit cm) The rotor The base
8.10 The following rotor assembly consists of a rotor, a shaft, and a base. The assem Poisson's ratio v=0.3, and density p = 7850 kg/m2. The base of the assembly is bly components are made of structural steel with Young's modulus E = 200 GP fixed on the bottom. Suppose a harmonic pressure load of magnitude 100 N cm is applied to the side surface of the base as shown below. Using the FEA compute: The frequency response of the directional deformation on the w The first five natural frequencies and normal thodes et direction) of the cylindrical shatt surface under the given harmonoload bonded contact for contact regions 100 Load A rotor assembly Assembly front view (unit cm) The rotor The base
Join a community of subject matter experts. Register for FREE to view solutions, replies, and use search function. Request answer by replying!