You are to develop a state diagram for a washing machine. The machine starts when a coin is deposited. It then sequences

[answerhappygod]

You are to develop a state diagram for a washing machine. The
machine starts when a coin is deposited. It then sequences through
the following stages: soak, wash, rinse, and spin. There is a
double wash switch, which, if turned on, causes a second wash and
rinse to occur. That is, a wash and rinse cycle is followed by
another wash and rinse cycle. There is one timer – you may assume
that each stage should take the same amount of time. The timer
begins ticking as soon as the coin is deposited, generates a T
signal at the end of the time period, and then resets itself and
starts again. If the lid is raised during the spin cycle, the
machine stops spinning until the lid is closed. You may assume that
the timer suspends ticking while the lid is raised. This
description was supplied to you by the manufacturer of a new
washing machine company called Comet Washers!! You have been asked
to design the controller for this machine. Identify your inputs and
outputs, and draw a state diagram that implements this finite state
machine. If you finish this part then you will get about half of
the total extra credit. If you professionally type up your design
report and also present the design of the controller by making use
of D-flipflops and extra combinational logic, you will earn rest of
the extra credit grade.
I need the D-flipflops Circuit. Please Will rate if you can give
me the part where it says "present the design of the controller by
making use of D-flipflops and extra combinational logic, you will
earn rest of the extra credit grade."
Please and thank you