-Configure devices based on the information given in the tables. You must write code to configure interface of router. -

[answerhappygod]

-Configure devices based on the information given in the tables.
You must write code to configure interface of router.
-Configure RIP (test connectivity A and B) and later cancel
RIP
-Add a static route (test connectivity between A and B
again).
You can use any PC, switch and router from the Cisco Packet
Tracer. your topology should work correctly. So, I recommend to use
the devices shown in the labs.
Please explain step by step and take a screenshot.
-Screenshot of codes to configure the router interface.
-Screenshot of codes of RIP configuration and cancellation. (Do
not forget to add ping results.)
-Screenshot of codes of static routing configuration. (Do not
forget to add ping results.)

Configure Devices Based On The Information Given In The Tables You Must Write Code To Configure Interface Of Router 1 (202.01 KiB) Viewed 97 times

Switch A Switch B B Router A Router B Straight-through cable Serial cable Rollover (console) Crossover cable Router EO Interface IP Address Subnet mask Router -A 192.168.1.1 255.255.255.0 Router - B 192.168.2.1 255.255.255.0 Router Clocking So Interface IP Address Subnet mask Router - A DCE 192.168.3.1 255.255.255.0 Router - B DTE 192.168.3.2 255.255.255.0 Computer IP Address Subnet mask Default Gateway PC-A 192.168.1.2 255.255.255.0 192.168.1.1 PC - B 192.168.2.2 255.255.255.0 192.168.2.1