2 b A large stamping press must have a part in place, the clamps engaged and the safety guard closed before the press ca

[answerhappygod]

2 B A Large Stamping Press Must Have A Part In Place The Clamps Engaged And The Safety Guard Closed Before The Press Ca 1 (106.01 KiB) Viewed 21 times

2 b A large stamping press must have a part in place, the clamps engaged and the safety guard closed before the press can operate. The pneumatic circuit needed for this type of machine is designed to minimize potential safety hazards. Part # Component Description Qty 1 5 2 2 2-position, spring offset, 3-way valve air pilot actuator manual actuator single acting, spring return cylinder 3 3 4 1 Table Question 2a: Component List for Stamping Press Pneumatic Control Assume that the cylinder is the prime mover for the press. (i) Sketch the layout of the components to achieve the above mentioned operation and (10 marks) (ii) Briefly explain the operation of the system Note: you do not have to draw the schematic for this circuit. (6 marks)